View Posts
MatterHackers Forum
This forum has been set to read-only for archival purposes. Please visit our Community Forum to ask and participate in active discussions.
Remove Post
How to tune extrusion multiplier
by
Daniel Pinvidic
I have a question regarding the Tuning controls for print speed and extrusion multiplier.
There are many articles which address the extrusion multiplier and how to find tune it. These involve making a print and measuring the extrusion width.
What indications would I look for during printing which would indicate that the extrusion multiplier should be tweaked under the Tuning Control slider?
Thanks,
Dan
Daniel Pinvidic
-
June 8th, 2014 at 10:40a.m.
@Daniel Pinvidic
The Extrusion Multiplier should be used when your printer is otherwise under-extruding. So if you think the layers are a bit sparse, that would be a good time to increase it. Not too difficult to use! :)
GriffinKahnke
-
June 9th, 2014 at 3:31p.m.