View Posts
MatterHackers Forum
This forum has been set to read-only for archival purposes. Please visit our Community Forum to ask and participate in active discussions.
Remove Post
A lot of pausing while printing
by
Marco048
I am running MC on XP. Printer has a Ramps board. It pauses a lot during printing - so much that it's unusable. The same pc prints fine with Repetier and Cura. Any ideas?
Marco048
-
July 15th, 2014 at 1:03p.m.
@Marco048
If you minimize MC does that help it print more smoothly. Just trying to isolate if it is drawing or something else.
jonathanformby
-
July 15th, 2014 at 2:37p.m.
That seems to do the trick, thanks!
Marco048
-
July 16th, 2014 at 10:01p.m.
For me on Mac OS X 10.8 I get the pausing as well, I switched to 3D view from layer view and it went away for me. I'm thinking (if mattercontrol is using java) that it could be a Java version issue?
Thomas
-
May 2nd, 2015 at 1:07p.m.