MakerBot Makerbot E3D Hotend Swap Kit
MatterHackers Digital Designs are easy to access and ready to print within MatterControl.
Digital Design files can be accessed using MatterControl Software or MatterControl Sync. When logged in, Digital Designs can be found within the "Purchased" folder of your MatterControl Cloud Library.
Design Files (4)
Makerbot E3D Hotend Swap parts
| Price: | FREE |
|---|---|
| License: | License To Make |
| Instant Digital Delivery | |
Makerbot E3D Hotend Swap printed parts. Includes designs for single and dual extruders (ie. Replicator 2 and 2X)
Questions
Is this filament made in the USA?
View 1 Response
Will these fit Raise3D Pro2 Plus?
View 1 Response
Filament spools from matterhackers fit Makerbot Replicator?
View 1 Response
how many meters of filament in 1 kg of your PLA?
View 4 Responses
| Price: | FREE |
|---|---|
| License: | loading |
| Instant Digital Delivery | |
not as much of a question but more of a tip, after having issues with this filament i found that running it at 220' c was best. anything lower and i was getting clogging issues. took me 3 failed prints and extruder height calibrations to figure out it just needed to run a little hotter. once set to 220'c it ran super smooth and print looked great.
Hey RedbeardRon,
I find that 205C works perfectly for me... It's all gonna depend on your setup. I have a CR-10S and an E3D V6 Hotend.
I also run the Heat Bed at 60C. Ideally I'd like to not heat the Bed, but if I don't then I have to use glue and I don't want the residue, even though it's easy to clean off.
fat