MatterHackers Surfboard Fins
MatterHackers Digital Designs are easy to access and ready to print within MatterControl.
Digital Design files can be accessed using MatterControl Software or MatterControl Sync. When logged in, Digital Designs can be found within the "Purchased" folder of your MatterControl Cloud Library.
Surfboard fins designed and 3D printed. Read about the project here.
| Price: | FREE |
|---|---|
| License: | License To Make |
| Instant Digital Delivery | |
Design Files (5)
Questions
Is this filament made in the USA?
View 1 Response
Will these fit Raise3D Pro2 Plus?
View 1 Response
Filament spools from matterhackers fit Makerbot Replicator?
View 1 Response
how many meters of filament in 1 kg of your PLA?
View 4 Responses
| Price: | FREE |
|---|---|
| License: | loading |
| Instant Digital Delivery | |
not as much of a question but more of a tip, after having issues with this filament i found that running it at 220' c was best. anything lower and i was getting clogging issues. took me 3 failed prints and extruder height calibrations to figure out it just needed to run a little hotter. once set to 220'c it ran super smooth and print looked great.
Hey RedbeardRon,
I find that 205C works perfectly for me... It's all gonna depend on your setup. I have a CR-10S and an E3D V6 Hotend.
I also run the Heat Bed at 60C. Ideally I'd like to not heat the Bed, but if I don't then I have to use glue and I don't want the residue, even though it's easy to clean off.
fat