Bambu Lab Bambu Lab High Temperature Plate (PEI) Spare Sheet

Remove the old sheet on the build plate.

Apply alcohol or detergent & water mix to the bare build plate.

• Isopropyl or anhydrous ethanol alcohol with a concentration of 90% or more is ideal.

Wipe the build plate clean of the cleaner and debris using a microfiber cloth.

Once the surface is dry and clean, align and attach the build plate to the Bambu Lab Sticker Applicator fixture.

• Maker sure the edge of the plate is aligned to to the edge of the fixture (red line shown in photo).
• This fixture is not required, but it can make the application process much easier.

Remove the clear film off the build sheet.

• The clear film is on the side you will be printing on.

Peel a quarter or half of the white adhesive liner off the back of the build sheet.

• It is not recommended to peel off the entire liner at this step because there is a larger margin for error as opposed to taking a slow and steady approach.

Align the sheet to the Bambu Lab Sticker Applicator fixture (the build plate from Step 4 should still be attached to the fixture) and then attach the sheet onto the build plate. Make sure the edges stay aligned with the fixture (red line in photo).

• Use your finger to stick the sheet onto the build plate.
• Proceed to Step 8 when you've ensured there are no air bubbles between the sheet and plate.

Use the Bambu Lab Sticker Applicator fixture in one hand to slowly press the sheet onto the plate while simultaneously using the other hand to remove the white adhesive liner.

Once applied, confirm there are no air bubbles between the sheet and plate before attempting to use it.

• If there are air bubbles, it's highly recommended to remove them before use as it will likely lead to some issues down the line.

Align the plate along the fixed points of the platform with the name of the plate facing you.

Lower the plate and secure it to the magnetic platform.