E3D E3D PT100 Temperature Sensor Cartridge
The E3D PT100 Temperature Sensor can be used in place of a thermistor for E3D's All-Metal HotEnds, and is compatible with E3D's new cartridge-style heater blocks. PT100's are able to measure temperatures up to 400 C, and are more accurate than most thermistors and thermocouples.
| List Price: | $21.00 |
|---|---|
| Price: | $21.00 |
| Price: | $... |
| Availability: | In Stock |
| Order Now: | Ships Tomorrow |
E3D PT100 Temperature Sensors are a great replacement instead of a thermistor, and measure higher temperatures at greater accuracy than most standard thermistors and thermocouples. E3D PT100's are compatible with E3D's new cartridge-style heater blocks.
PT100 Temperature Sensors require your electronics to support RTD Sensing devices, or you will need an amplifier board (sold separately).
Questions
Will this fit a dragon HF?
The wires in the picture are blue. The PT100 sensor wires should be red. Is that just the case of using a stock picture?
Will this fit in a volcano block?
What is the connector type? I'd like to know if it's compatible with the JST type connectors I currently have.
Will this work for the sidewinder x1v
Does anyone no if this will work with a Prusa i3 MK3?
Will this work with the board in a Robo 3d R1+? It already has a v6 hotend
Will this work on a CR-10 board?
Purchased a Titan Aero that came with a PT100 cartrige. The PT100 is measuring 115K ohms at 71 degrees F. and 1.4K at 275 degrees. Why?. Measured with Fluke 87 meter, PT100 still installed in hot end but removed from Titan. All sitting on my work bench.
Do the electronics on the BCN3d Sigma support RTD Sensing devices? Or would I need to get a amplifier board?
So, how do I mod a RAMPS 1.4 board, on a Ultimaker Orginal printer, to use this?
What is the diameter of the sensor cartridge? Can this be simply installed by swapping thermistor cartridge in e3d hotends?